VEVOR TF15 Mode D'emploi page 5

manner.
9.Be sure to wear ANSI approved safety gloves when using tools or
equipment.
10.Release load before service or maintenance.
11.Avoid off-center loads. Do not operate if workpiece tilts or binds during
compression.
12.STOP and release compression if you suspect imminent structural
failure. If safe, inspect thoroughly and reposition before proceeding.
13.Keep bystanders out of work area
14.This product is not a toy. Keep it out of reach of children.
The Warnings,Cautions,and Instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product,but must
be supplied by the operator.
Refer to the Parts Diagram and Parts List on this booklet.
1.Attach the handle(9) to the frame(10) with two flat washers(20) and two
bolts(19).
2.Attach the foot lever(50) to the lift lever(47) with bolt(49) and lock
washer(48).
3.For TF50, The table and the rest part is packed separately. Attach the
table ( 1) to the link assembly(2) with two link shafts(3a) and two c-clip(4).
ASSEMBLY