VEVOR MJ-2000B-DWJ Mode D'emploi page 7

3. Turn handle clockwise to raise.
4. Turn handle counterclockwise to lower.
Note: Remember that the jack must not interfere with the vehicle or trailer
when turning or passing over speed bumps, boat ramps, etc.
1. Occasional cleaning with mild soap and water along with light oil
lubrication of pivot points will prolong peak performance and appearance.
2. Periodically check whether the screws are loose.
3. Before each use, inspect jack tubes and replace if bent or damaged.
4. The following procedures should be performed at least annually:
The internal gearing and bushings of the jack must be kept lubricated.
Apply a small amount of automotive grease to the internal gearing by
removing the jack cover. Rotate the jack handle to distribute the grease
evenly. The axle bolt and nut assembly of the caster wheel must also be
lubricated with the light weight oil.
If this product is used in a marine environment, flush the jack assembly
and bushings with fresh water, and apply fresh lubricant.
MAINTENANCE
- 6 -