Flex FX1371A Manuel De L'utilisateur page 14

WARNING
product damage due to a short circuit, never
immerse your tool, battery pack or charger
in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This compact impact driver must be used only with the battery packs and chargers listed
below:
2.5Ah 5Ah
FLEX FX0111 FLEX FX0121
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
TIGHTEN AND LOOSEN SCREWS, NUTS
AND BOLTS (FIG. 10 AND 11)
Select the T1 or T2 mode as necessary, based
on your application. For more details see
related section: Mode Selection. For mode 1,
2, or 3: variable-speed control must be used
with caution for driving nuts and bolts using
socket-set attachments. The best technique is
to start slowly, increase speed as the nut or bolt
runs down, and then set the nut or bolt snugly
by slowing the tool to a stop. If this procedure
is not followed, the tool will have a tendency to
torque or twist in your hand when the nut or bolt
seats.
It is advisable to perform a trial run on a scrap
material to determine the best mode selection.
a. Install a suitable bit.
b. Apply just enough pressure to keep the bit
engaged on the screw or nut.
c. For mode 1, 2, or 3, apply minimal pressure
to the variable-speed trigger switch initially.
Increase the speed only when full control can
be maintained.
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
If any parts are damaged
or missing, do not operate
Battery Pack
8Ah
FLEX FX0221
WARNING
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
12Ah
FLEX FX0231
Fig. 10
-14-
Do not attempt to modify
this tool or create
To prevent accidental
starting that could cause
Charger
FLEX FX0411 FLEX FX0421