M1.1.BG20IM.NLFREN - 18102022
EN
7. Install the spark plug carefully by hand. Pay attention not to overlap the screw thread.
8. After installing a new spark plug by hand, screw it with a spanner for a half circle in order to press the gasket tightly. If an
old spark plug is installed, you only need to screw it from one eighth circle to one fourth circle after it is fixed.
9. Re-install the cap of the spark plug.
10. Re-install the cover of the spark plug.
LOOK OUT!
•
The spark plug must be fixed firmly, or else it will become very hot and damage the generator.
•
Do not use the spark plug whose thermal measurement range is not suitable.
generator.
9 Transport and storage
In order to avoid the generator leaking oil during transport of temporary storage, make sure to switch off the generator, keeping
it at a standing position under normal operation. Turn the ventilating pole of the gas-filling lid to the "close"position (counter-
clockwise) after the engine is totally cooled.
WARNING!
When transporting the generator:
generator
•
Do not let the gas spill out of the gasoline tank. (The top of the gas-filling tank should have no gas).
•
When the generator is placed on a vehicle, do not run the engine. You should take the generator down from the car
and operate it in the draught.
•
When you take the generator to the car, avoid exposing it to sunshine. If it is pout in sealed carriage for a long
time, the high temperature of the carriage may cause gas to boiling away, thus leads to burn.
The cars loaded with generator should not bump on uneven roads for a long time. If it has to travel on such roads,
the gas in the gasoline tank should be discharged thoroughly in advance.
Before the generator is put into a long-time storage, you should:
generator
1. Make sure the storage area is clean and dry.
2. Discharge the gas thoroughly.
WARNING!
•
Gas is very easy to burn or explode under specific conditions.
•
Smoke and flame are strictly forbidden near the gas.
generator
generator,
generator:
generator
generator
generator
59