Guardian 98120 Instructions D'utilisation

GUARDIAN
Please follow these instructions carefully before using your new Safe-T-Pole in order to familiarize
yourself with the safe and correct usage.
Adjustment range: 7' 9" – 8' 5.5"
1. Adjusting collar must be tightened with sufficient force to prevent any
movement during use, especially when being installed on carpeted floors.
2. Ceiling and floor contact surfaces must be structurally sound, dry and free of
dirt and debris. Make sure acoustic or textured ceilings are smooth at area
where ceiling bracket will rest.
3. Mount ceiling bracket (E) at right angles to ceiling studs to avoid ceiling and
floor damage from excessive tightening.
4. Check adjustment periodically to assure safe use of your Safe-T-Pole.
5. Not to be used with suspended ceilings.
INSTALLATION
Tool Required: Phillips Screwdriver
Parts List:
Pole ..................................Part A
Floor Mounting Plate............Part B
Threaded Adjusting Pipe .......Part C
Adjusting Collar ..................Part D
Ceiling Bracket ....................Part E
A. Screw the collar (D) onto the pipe (C). Tighten the screw
in the bracket (E) into the nut inside of the pipe (C).
B. Place floor mounting plate (B) in the approximate floor
position desired. Insert the pole (A) onto the receiver lip
of the floor mounting plate (B).
C. Determine approximate distance from top of pole to ceiling
and adjust the adjusting collar (D) on threaded pipe,
slightly less than pole-to-ceiling distance.
D. Hold the ceiling bracket (E) against the ceiling. Turn the
adjusting collar (D), adjusting the pipe until the Safe-T-
Pole is sufficiently rigid.
®
SAFE-T-POLE USER INSTRUCTIONS
Please read carefully before installation and use.
Failure to comply may result in serious injury.
Model: 98120
Ceiling Studs
Ceiling
E
E
D
C
A
B