ProFusion NDB-1Y Manuel Du Propriétaire page 7

If your heater fails to operate, please follow these procedures prior to contacting
Customer Service.
Problem
Heater is not plugged into a
120V polarized
outlet/receptacle.
Heater will not
power on
Breaker/Fuse has been
tripped.
Room temperature has been
Unit is not
warmed up to thermostat
heating
setting
A drop of oil fell on the
heating coil during the
The heater is manufacturing process. It
creating will quickly evaporate and
should not occur again.
a burning
smell.
Check & ensure there are no
combustible materials
within 3' (0.9 m) of the heater.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF, DOING
SO COULD VOID THE WARRANTY AND CAUSE DAMAGE OR PERSONAL INJURY.
TROUBLESHOOTING
Probable Cause
Ensure unit is in OFF position. Plug in
unit and attempt to turn on again.
Please check your electrical box to
confirm the breaker has not been
blown. This may occur if the unit is
sharing a receptacle with another high
power consuming appliance. Ensure
unit is in OFF position. Plug in unit and
attempt to turn on again.
Attempt to plug unit into another
independent output in the house.
To resume heating, adjust thermostat
temperature to a higher setting.
Ensure room in which heater is situated
is well ventilated.
Remove the combustible materials
preventing air intake into the heater.
7
Solution