Switching Off - Haussmann 59595071 Guide D'utilisation

both sides and pulling the battery out of the power tool toward the rear.
d) Do not use force when inserting the battery pack. If the pack does not slide in
easily, it is not being inserted correctly.
Changing bits
CAUTION!
Always be sure that the tool is switched off and the battery pack is removed
before carrying out any work on the tool.
1) Hold the ring and turn the sleeve counter-clockwise to open the chuck jaws.
Place the bit in the chuck as far as it will go.
3) To remove the bit, hold the ring and turn the sleeve counter-clockwise.
OPERATION
Starting Operation
Switching on:
To start the tool squeeze on the On/Off switch(7) and then keep it pressed down.

Switching off:

To stop the tool, release the On/Off switch (7).
Reversing the Rotational Direction
This tool has a reversing switch to change the direction of rotation. Push the
reversing switch lever from the left (2) side for clockwise rotation or from the right (3)
side for counterclockwise rotation.
When the reversing switch lever is in the neutral position, the switch (7) cannot be
pressed.
Setting the Torque
The fastening torque can be adjusted in 20+1 settings by turning the adjusting ring
so that its graduations are aligned with the pointer on the tool body.
1. Adjusting ring
2. Graduations
3. Pointer
20