Uline H-5580 Mode D'emploi
Les langues disponibles
Les langues disponibles
Table des Matières
H-5580, H-5581, H-5582
H-5583, H-5584, H-5585
BALL TRANSFER TABLES
TOOL NEEDED
9/16" (14 mm) Wrench
BOLTING TABLE FRAME(S) TO H-STAND
LEG SUPPORTS
NOTE: H-Stands are sold separately. Hardware
included: four hex head bolts and four flange
nuts.
1.
Hardware is pre-screwed into the tops of the
H-Stands. Remove the hardware. (See Figure 1)
Figure 1
2. Bolting two H-Stands to one table frame: Position
H-Stands on the end of the table frame. Fasten bolts
through table and H-Stand. (See Figure 2)
Figure 2
PAGE 1 OF 6
1-800-295-5510
uline.com
ASSEMBLY
3. Bolting a single H-Stand to two table frames:
Position the H-Stand halfway between the ends of
two table frames, aligning one hole on each table
with the H-Stand. Fasten bolts through tables and
H-Stand. (See Figure 3)
NOTE: Each table frame includes mounting
holes for an optional center leg support.
Adding a third support increases weight
capacity.
Figure 3
Para Español, vea página 3.
Pour le français, consulter la page 5.
0624 IH-5580
Table des Matières
Manuels Connexes pour Uline H-5580
Sommaire des Matières pour Uline H-5580
-
Page 5: Outil Requis
H-5580, H-5581, H-5582 1 800 295-5510 H-5583, H-5584, H-5585 uline.ca TABLE À BILLES POUR CONVOYEUR OUTIL REQUIS Clé 14 mm (9/16 po) MONTAGE BOULONNER UN/DES CADRE(S) DE TABLE AUX PATTES DE 3. Fixation d'un seul support en H à deux cadres de table: Positionnez le support en H à... -
Page 6: Montage Suite
MONTAGE SUITE RACCORDEMENT DE PLUSIEURS TABLES ENTRE ELLES Retirez les pièces de fixation prévissées. Fixez les boulons aux extrémités des deux cadres. (Voir Figure 4) Figure 4 1 800 295-5510 uline.ca PAGE 6 OF 6 0624 IH-5580...