Operation; Connect The Wiring; Lamp Replacement - Silhouette Select DWRH302SSST Guide Du Propriétaire

OPERATION

Always turn the hood ON before cooking in order to establish
an air flow in the kitchen. After turning off the range, let the
hood run for a few minutes to clear the air.
Heat Sensor:
The hood is equipped with a heat sensing thermostat. If the
safety device detects heat in excess of 158°F (70°C) above the
cooking surface, it will turn on or speed up the fan. If the fan is
not on or running at a low speed, the heat sensor will override
the normal fan control and run the fan on high speed. When
the temperature level drops below 158°F (70°C) the fan speed
will revert back to its original setting.
Operate the hood as follows:
Power
To activate the rangehood, press the power button. Once
activated, the buttons and LED light up.
Light
The Silhouette Select™ rangehood are equipped with 3 light
settings High, Low and Off. Press the light icon once and the
20w halogen bulbs turn on providing full task lighting. Press
the icon again and this reduces the illumination to 50%. Press
the icon a third time to turn the lights off.
Filter
After 100 hours, the filter icon lights up and the user must re-
move the filter, clean it and replace it in order to reset the icon.
Press and hold the power button for 3 seconds to reset after
cleaning the filter.
Timer
Silhouette Select™ rangehoods include a convenient feature
that allows the range hood to continue to run for an additional
5 minutes to expel residual vapors and odours after cooking.
When the timer button is pressed once the current fan speed
will continue to run for a duration of 5 minutes and the timer
icon appears on the LED display. Push the timer button a
second time to cancel the timer and remove the icon from the
LED display.
Fan
Your Silhouette Select TM rangehood offers 3 fans settings
low, medium and high. To activate the fan press the fan button
and the fan starts at the low setting and the corresponding icon
appears on the LED display. Press the fan button again and
the blower increases to the medium speed. Press a third time
for the highest speed and a fourth time to turn the fan off.
Icon for low speed
Icon for medium speed
Icon for high speed

CONNECT THE WIRING

Connect house power cable to rangehood wiring,
Ground Wire: GREEN
Fire Wire : BLACK
Zero Line : WHITE

LAMP REPLACEMENT

1. Remove Filters.
Remove tap holding filters in place. Pull down on filter tabs and
lift filters out. Set filters aside.
2. Lamp Replacement.
1. Pull out lamp from inside, release the connecter.
2. Install a new lamp, then connect the wire again.
3. Re-install the filter.
5