SEARIAL CLEANERS BEBOT Guide Demarrage Rapide page 3

Attaching the sifter
Warning: never attach or detach the sifter when the X-Bot is
switched on. Do not move the X-Bot forward otherwise you risk
shearing the cable.
1. Align the X-Bot pallet with the sand sifter pallet.
2. Move the X-Bot backwards to align the attachment systems
on the X-bot and the sifter.
3. Switch off the X-Bot and connect the sifter cable to the rear
of the X-Bot.
4. Switch the X-Bot back on.
5. Use the "bracket" and "sifting depth" controls to dock
the two connector systems.
6. Turn off the remote control and the BeBot.
7. Once the sifter is docked, insert the pin.
Unloading
Ramps are provided to enable the BeBot to safely descend
from the pallets.
Raise the sifter unit to maximum height and move the BeBot
off the pallet using the ramp.
Maintenance recommendations
Storage
a dry place
Always store the BeBot in
The battery should be recharged every 3 to 5 weeks during long-term storage to prevent deterioration.
Do not leave the battery discharged for more than 48 hours.
Cleaning
Clean the BeBot after each operation:
• We recommend using an air blower to remove sand easily.
• You can also use water. Never spray water on the electronics box or battery.
, at a temperature between 5 °C and 30 °C.
Battery Electronics box
3
Quick Start
BeBot