Makita JS1300 Manuel D'instruction page 5

Removing cutting head
1
2
3
004688
Use the hex wrench to loosen the three screws which
secure the cutting head. Pull the cutting head straight
out to remove it with turning it left and right alternately.
Removing shear blades
1
2
3
4
5
004689
Remove the three screws which hold the cutting head.
When removing the second screw, be careful not to fall
the sleeve. Then the blades can be removed easily.
When removing the blades, hold the blades and the
sleeve so that they do not fall from the cutting head.
Installing shear blades
1
2
3
4
5
004690
Install the sleeve and tighten the three screws after
inserting the center blade, side blade L & R into the
cutting head. In this process, the screw heads should be
protruding 2 - 3 mm (1/16"-1/8") from the cutting head
surface.
If you will tighten the screws excessively, the cutting
head cannot be installed to the tool.
1. Cutting head
2. Screws
3. Loosen
4. Hex wrench
4
1. Screws
6
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve
6. Cutting head
1. Cutting head
2. Sleeve
3. Side blade R
4. Center blade
5. Side blade L
6
6. Screws
Installing cutting head
1
2
3
004691
CAUTION:
Secure the cutting head firmly. Otherwise it can
•
rotate during operation and can cause serious
injury.
Insert the cutting head into the tool with turning it left and
right alternately. Then tighten the three screws with the
hex wrench.
OPERATION
CAUTION:
Edges and chips of the workpiece are sharp. Wear
•
gloves. Otherwise it can cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece
surface.
1
2
3
004697
Adjusting shear blade
1
2
3
4
5
004698
Adjust the side blade L so that the curl of waste material
does not contact the cutting head or the workpiece. Use
the hex wrench to loosen the three screws which hold
the cutting head. Move the side blade L back and forth to
adjust it. Then tighten the three screws with the hex
wrench.
5
1. Cutting head
2. Screws
3. Tighten
4. Hex wrench
4
1. Side blade
surface
2. Side blades
3. Center blade
4. Workpiece
4
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve