Uline H-7856 Mode D'emploi

π
H-7856
EXCEL WALL GUARD –
STAINLESS
TOOLS NEEDED
Mount with four strips of construction grade
3M adhesive tape (included).
1. Clean the wall surface with isopropyl alcohol prior to
installation. Make sure the surface is dry and free of
any dust and debris.
2. Center the wall guard underneath the hand dryer so
that the top of the wall guard is 1" below the bottom
of the dryer.
3. Carefully measure and mark the wall surface
for placement of the wall guard with a pencil or
temporary marker. (See Figure 1)
4. Four strips of double-sided adhesive are included
for each panel. Apply strips to smooth side of panel
as follows:
a. Lay out strips as shown in Figure 1.
b. Remove one strip and apply to either right or left
side to start.
c. Press each strip firmly onto the wall guard as it is
applied.
d. Continue until all four strips are applied.
CAUTION! Alignment is critical. Once placed
on the wall, the wall guard cannot be
repositioned.
Clean the installed wall guard with mild soapy water
and a soft cloth. Mild dish soap mixed with water in a
spray bottle works best.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTALLATION
Figure 1
5. Align the top edge of the wall guard with the
markings on the wall and firmly press into place
against the entire surface of the wall guard.
MAINTENANCE
Pour le français, consulter la page 3
15⁄"
⁄  " 1" 3⁄" 1" 3⁄" 1"
1/2"
Radius
Corner
Recommended location of adhesive strips
OPTIONAL: After guard is applied to wall, user
may add silicone sealant around the edge.
WARNING! Do not use any cleaner that
contains ammonia or abrasive cleansers to
clean the surface.
Para Español, vea página 2.
⁄"
3⁄" 1" ⁄  "
31⁄"
0721 IH-7856