Novy 680 Mode D'emploi Et D'installation page 16

Maintenance
Maintenance of the grease filter
The hood contains one metal filter which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don't reset, the LED lights will continu blinking.We
advise you to clean your filter twice a month for an
optimal operation.
Access to the filter
Open the rotating valve (A). Protect the hob. You
can take the grease filter (B) from the hood by
pulling the handle on the filter. The filter will come
down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Belangrijk! Indien de bovenvermelde instructies
niet worden uitgevoerd, ontstaat er door een
te sterke vervuiling, kans op brandgevaar en
rendementsverlies
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning indication:
The red LED will light up after 200 working hours
(time to regenerate the used carbon filter).
Follow the instructions below:
• Open the bottom plate.
• Take the filter from the hood.
• Take the Monoblock recirculation filter from
the hood.
ATTENTION: Do not pull the fabric of the
Monoblock filter!
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. The best solution for this
is to immediately regenerate the filter.
Reprogramming:
Press + and – simultaneously for 5 seconds, the
red LED flashed 3 times for confirmation (if this
programming is not done, the program will be set
automatically after having switched on the device
10 times).
Deactivate the program:
Simultaneously press + and – for 5 sec. until the
third green LED flashes 3 times.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet
cloth and a mild detergent to clean the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel. The
stainless steel surfaces can be treated with Novy
Inoxcleaner (906.060) after cleaning.
EN 16