VALBERG FL3.2 Consignes D'utilisation page 12

B
Product usage
While pressing the dirty water cup release button downward, pull to remove the cup.
Hold the cup and remove the HEPA filter and the lid, and then pull out the separator
in the cup.
Empty the cup and remove any dirt residues on the inner wall of the cup and on the
dirt separator with the cleaning brush provided. Then, rinse the cup clean.
Remove the HEPA filter and rinse it under tap water. Then, let it air-dried before
placing it back to the dirty water cup.
Place the cup back to the lower body. Push the cup in until it clicks into place.
Self-clean
NOTE:
We recommend that you:
• Clean the dirty water cup before and after performing the self-cleaning
function.
• Clean the charging base right away if any dirty residues remain on the charging
base after using the self-cleaning function.
1. To perform rolling brush self-cleaning, place the Floorwasher back to the charging base.
2. While the Floorwasher is in the charging base, standing upright, press
the handle.
3. After performing the self-cleaning, the Floorwasher enters charging mode.
11 EN
on the top of