Uline S-18249 Mode D'emploi
Liens rapides
S-18249
S-18995
HEAVY DUTY
WOOD CRATE
1.
Identify boards and clip leg lengths. (See Figure 1)
Figure 1
Top & Base
Milled Edge Perimeter
Clip x 24 (S-18249)
2. Attach milled-edge side to base with clips.
(See Figure 2)
Figure 2
NOTE: Always wear safety glasses when
installing or removing clips.
3. Attach clip so that the long leg spans across the
edge of the overlapping board. Push the knee of
the clip until it snaps into slot. (See Figure 3)
Figure 3
PAGE 1 OF 6
1-800-295-5510
uline.com
ASSEMBLY
Side x 4
1 Vertical Milled Edge
Clip x 20 (S-18995)
Pour le français, consulter les pages 5-6.
4. Attach side to side and base. (See Figure 4)
Figure 4
5. Attach side to side and base. (See Figure 5)
Figure 5
6. Attach side to both sides and base. (See Figure 6)
Figure 6
Para Español, vea páginas 3-4.
0822 IS-18249
Manuels Connexes pour Uline S-18249
Sommaire des Matières pour Uline S-18249
- Page 1 Top & Base Side x 4 Milled Edge Perimeter 1 Vertical Milled Edge Clip x 24 (S-18249) Clip x 20 (S-18995) 5. Attach side to side and base. (See Figure 5) 2. Attach milled-edge side to base with clips. (See Figure 2)
- Page 2 (See Figure 9) Figure 7 Figure 9 8. Be sure top is fully seated, then attach with NOTE: Always cover clip with hand when remaining clips. (See Figure 8) removing. Figure 8 1-800-295-5510 uline.com PAGE 2 OF 6 0822 IS-18249...
- Page 3 Diagrama 3 y Base Borde con Relieve 1 Lado Vertical con Relieve 24 Clips (S-18249) 20 Clips (S-18995) . (Vea Diagrama 4) Fije el lateral al lateral y a la base 2. Fije el lado con relieve del lateral a la base usando clips.
- Page 4 NOTA: Cuando vaya a quitar un clip, cúbralo siempre con la mano. Diagrama 7 8. Asegúrese de que la parte superior esté bien colocada y luego fíjela con los clips restantes. (Vea Diagrama 6) Diagrama 8 800-295-5510 uline.mx PAGE 4 OF 6 0822 IS-18249...
-
Page 5: Montage
Périmètre du bordé Cote au bord meulé meule vertical Attache x 24 (S-18249) Attache x 20 (S-18995) Fixez un panneau latéral au panneau latéral et à la base (Voir Figure 4) 2. Fixez à la base un panneau latéral au bord meulé à... -
Page 6: Montage Suite
REMARQUE: Maintenez toujours votre main sur l'attache au moment de la retirer. Figure 7 8. Assurez-vous que le dessus est bien entré en place, puis fixez-le à l'aide des attaches restantes. (Voir Figure 8) Figure 8 1-800-295-5510 uline.ca PAGE 6 OF 6 0822 IS-18249...