Hilti C 4/12-50 Mode D'emploi page 8

Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 Information displayed
3.4.1 Indicators on charger and battery
LED 1
Off
Flashes red
Shows green
Shows green
Shows green
Shows red
3.4.2 Li-ion battery state of charge display
Status
4 LEDs show.
3 LEDs show, 1 LED flashes.
2 LEDs show, 1 LED flashes.
1 LED shows, 1 LED flashes.
1 LED flashes.
4 Technical data
4.1 Technical data
Weight
Output voltage
Output power
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Switching the charger on
▶ Plug the supply cord into the power outlet.
▶ LED 1 on the charger shows green.
5.2 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
4 English
LED 2
Off
Off
Off
Flashes green
Shows green
Off
Significance in relation to charger
No AC supply or charger defective
Battery too hot or too cold.
Charger ready for use
Battery is charging.
Battery fully charged
Charger malfunction.
Meaning
State of charge: 100 %
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: < 25 %
C 4/12-50
0.35 kg
10.8 V
50 W
3
2373346
*2373346*