Humanscale NeatCharge Instructions D'assemblage page 3

NOTE
Charger does not work at close range. The work
surface thickness must be at least 15mm (0.6")
and no more than 30mm (1.2").
STEP 1:
Choose a charging location on the desk, making
sure there is space beneath for the charger.
Clean and dry the surface before placing the
charging location sticker. Remove adhesive
backing and place the charging location sticker
on work surface in the desired location.
STEP 2:
Place a stack of 2 included magnets on the
power symbol in the center of the location
sticker.
3