Gorgy Timing RT B GPS Mode D'emploi page 14

WARNING! Read the section that follows very carefully before installing your equi-
pment. It gives the safety instructions to follow during installation.
To protect your equipment, connect power on UPS (Uninterruptible Power Supply).
The electrical installation to which the equipment is connected must comply with
the NF C 15-100 standard.
This device does not have a primary power switch. A power protection system
(circuit-breaker or disconnecting switch), that is easy to access must be built into
the wiring installation. This device must support the nominal voltage and current
values specified on the clock.
In Europe: to comply with European regulations on the protection of persons and
the environment, you must dispose of this equipment in a collection site provided
for this purpose (separately from household waste). Contact your reseller, collec-
tion site or the competent lcoal authorities for more information.
Toute modification ou ouverture du produit sans l'accord du SAV entraîne la perte
de la garantie.
All maintenance operation shall be conducted with power shut off, including sys-
tems connected on relay outputs if any.
Generally, the power cable (220V) and transmission cable (of time signal) shall
not be very close to each other, so as to avoid interference (keep the distance of
a few centimeters).
Gorgy Timing disclaims all responsibility in case of accident or damage caused by
an improper use of the product.
GORGY TIMING products are compliant with the following standards: CE, EN 60950,
En 55022, En 50024
14
IMPORtant SafEtY InStRUCtIOnS
MDE-RTBGPS-4080V1.2