Uberhaus 72255110 Guide De L'utilisateur page 18

Step 11:
K 2b
J1
K 1b
K 2a
C 1
J
K 1a
C
J
K 1a
¡ Á 2
C
11.1. Insert the Side Roof Panels (K1a & K1b) between the Rails (C & C1) and the Roof Holder Bars
(J & J1), which form a triangle on the sides of the gazebo.
11.2. Insert the Side Roof Panels (K2a & K2b) between the Rails (C & C1) and the Roof Holder Bars
(J & J1), which form a triangle on the sides of the gazebo, until they reach the Side Roof Panels (K1a
& K1b).
CAUTION:
One side of each roof panel has been treated to provide UV protection. Make sure that the side treated with
UV protection is facing outward. This step is very important – if the roof is not assembled as per the
instructions shown, it will not be covered by the warranty.
NOTE:
The panels are covered with a plastic film to identify which side has UV protection. Once this film is removed,
it is not possible to tell which side protects against UV rays. Therefore, it is recommended to remove the film
only once the panels have been installed, one at a time.
Page
18