Uline H-5047 Guide Rapide

H-5047
APPLIANCE HAND TRUCK –
2-WHEEL
WARNING! Check truck and all hardware for
wear and tightness before use.
• Do not use if nylon belt is worn or cut.
• If climber belt is worn, immediately remove unit
from service and repair before use.
• Do not allow belt to twist when securing load.
1. Release the ratchet tightener, wrap the belt around
the load, and secure front clasp. Be sure to return
the ratchet tightener to the locked position once the
belt is clasped. (See Figures 1-2)
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
SAFETY
OPERATION
Front Clasp
• Firmly tighten belt around load before moving.
• Approach stairs or inclines with caution.
• Use only with assistance when going up or down
stairs or inclines.
• Use extreme caution when moving on uneven
floors.
2. Use ratchet handle to tighten the belt and secure
the load. (See Figure 2)
Figure 2
Lock
Ratchet Tightener
in Locked Position
Belt
Para Español, vea página 2.
Pour le français, consulter la page 3.
Release
Ratchet
Handle
0421 IH-5047