Vcr/Dvd Punch-Through; Record Key; Additional Features; Set Time For Lcd Display - Rca Rcu811 Mode D'emploi

RCU811US_IB_REVB 9/26/03
All manuals and user guides at all-guides.com

VCR/DVD Punch-through

Your RCU811 punches through the six transport keys (REVERSE, PLAY, FORWARD, RECORD,
STOP and PAUSE) to VCR or DVD Mode, whichever was used most recently. Punch-through to
VCR or DVD transport keys is only allowed for TV, VCR, DVD and CABLE Modes. The SAT and
CD/AUDIO transport keys are dedicated to their programmed modes.
The LCD shows component changes for the VCR or DVD Punch-through keys if they are pressed
in other modes (e.g., If you are in CABLE Mode and you press and release PLAY, either VCR or
DVD is displayed in the LCD).

Record Key

In the VCR and AUDIO/CD Modes (including Punch-through), the RECORD key must be pressed
twice before the command is sent. This is also true if a VCR component is programmed under any
other mode. The exceptions are for TV, DVD, CABLE and SAT codes, where the RECORD key
transmits the command after only a single RECORD keypress.

Additional Features

Set Time for LCD Display

You can set the time the LCD displays. To set the time for the status display, follow these steps:
1. Press and hold the SETUP (S) key for 2-3 seconds
until the LCD display shows the Setup Mode? Screen.
2. Release the SETUP (S) key.
3. Press and release the SETUP (S) key repeatedly
until the Clock Setup Screen 1 appears.
4. The cursor under the Hours digits (HH) will be flashing.
Press and release the LEVEL+/UP ARROW or LEVEL-/DOWN
ARROW keys to select the hour. Press and release the ENTER
key once you have reached the correct hour.
To adjust the AM/PM designation, repeatedly
Note:
scroll through the hour settings.
5. The cursor under the Minutes digits (MM) now flashes.
Press and release the LEVEL+/UP ARROW or LEVEL-/DOWN
ARROW keys to select the minutes. Press and release the
ENTER key once you have reached the correct minute setting.
The LCD display shows the Success Screen, then returns to
the normal time display. The time setting is now complete.

Backlighting

Backlight illumination is generated by an Electroluminescent (EL) panel that gives a blue light,
which lets you see the status display in the dark. Backlight illumination is toggled on or off with
successive keypresses of the BACKLIGHT key. When toggled on, the backlighting remains on as
long as keys are being pressed. The backlighting will turn off five seconds after the last keypress.
Once the Backlight time has expired, the Backlight does not reactivate until a key is pressed again.
If the Backlight illumination is on, and the BACKLIGHT key is pressed again, the Backlight turns off.
14
11:54 AM Page 14