After Use; Cleaning And Maintenance - Thane H2O SteamFX Pro Guide D'utilisation

After Use

1. Unassemble each accessory when finished cleaning. Disconnect the power supply and pour out the remaining
water in the Water Tank. Allow the steam cleaner to cool down for 3 to 5 minutes.
2. Remove the Mop Cloth (CAUTION: Accessories may still be hot) ) and clean in washing machine or by hand.
3. Store the steam cleaner in a dry location away from direct sunlight.
TIP: To ensure top performance, it is recommended to replace the Mop Cloth every 2-3 months.
!
WARNING
To avoid damage to the Mop Cloth, do not twist forcibly.
!
WARNING
To avoid calcification of the heating element, disconnect the power supply after the steam stops (when the green indicator is on).
12
Cleaning & Maintenance
DISCONNECT THE UNIT FROM THE POWER OUTLET DURING CLEANING AND MAINTENANCE.
!
DO NOT IMMERSE THE H2O SteamFX™ Pro HANDHELD STEAMER IN WATER.
WARNING
Cleaning procedure to remove lime scale
If your H2O SteamFX™ Pro begins to produce steam slower than usual or stops producing steam, you may need to remove lime scale. It is
necessary to remove lime scale on a regular basis, every 25 times you use a full tank of water or once a month, especially in areas with hard
water. To remove lime scale from your H2O SteamFX™, please follow these instructions:
Using a cleaning solution
1. Prepare a solution of 1/3 white vinegar and 2/3 water and add to the Water Tank.
2. Ensure that steam released is aimed away from any surrounding objects. Plug the appliance into a properly grounded electrical outlet,
turn it ON and allow the unit to produce steam until the vinegar/water solution is used up.
3. Repeat the above procedure as many times as necessary until a normal steam flow is achieved.
4. Fill the Water Tank with fresh water and rinse out.
5. Fill the Water Tank with fresh water again, and release steam through the system until the Water Tank is empty.
6. Perform a test cleaning on a suitable isolated area after each lime scale removal to ensure that there is no debris left in the system.
To clean calcium deposits building up inside the Water Tank:
Add 1-2 tablespoons of white vinegar to a full Water Tank, close the Water Tank Cap and shake the contents. DO NOT TURN THE APPLIANCE ON.
Let the unit sit for a few hours. Empty the Water Tank and rinse with clean water until it rinses clear.
Cleaning blocked steamer accessories:
Due to the high mineral content of water in some areas, some calcium buildup might develop inside the tip of the Nozzle. To clean, it is recommended
to use a spray lubricant. Spray a small burst or two of the lubricant inside the tip of the Nozzle. After spraying the lubricant, fill the steamer with water
and run a continuous jet of steam through the affected accessory for several minutes to remove the deposit.
IT IS RECOMMENDED PERFORMING THIS PROCEDURE IN A PROTECTED AND WELL-VENTILATED AREA.
13