Hornbach 6145083 Manuel D'installation Et De L'utilisateur page 105

Install stand pole foot
Use a 14 mm masonry drill to
drill the holes for the stand pole
at the appropriate marks on the
ground. The holes should be
62 mm apart (centre to centre)
and more than 70 mm deep.
The distance from the wall must
correspond to the width
(W ≤ 300 cm) of the side blind.
Insert the rawl-bolts in the drill
holes and install the foot of the
stand pole. The ground must
be the same level as the wall-
mounted side blind.
Install stand pole
Attach the stand pole to its foot
by turning it counter-clockwise.
3b
62
≤ 300 cm
62
70
ENGLISH | 105