Parts Diagram - Russell Hobbs Rhmf80 Instructions Et Garantie

PARTS DIAGRAM

HOW TO ASSEMBLE YOUR MIST FAN
1. Unpack all the parts of the fan and remove all packaging. Dispose of the packaging
safely.
2. Take out the base nut under the body.
3. Use the base nut to assemble the body to the base (black base holes
are in downward position).
4. Place and fix the wheels into their holes on the base and press them in
firmly. The wheels have been supplemented with the feature of clips.
Thus, you do not need to employ any screwdriver or special wrench to fix
the wheels.
5. Take out the blade cap from the shaft turning it clockwise.
6. Take out the rear guard mounting nut turning it anti-clockwise.
7. Insert the rear guard into the motor matching 3 rods on the front side of the motor
(the handle will direct upwards ) to 3 holes of the rear guard.
8. Fasten the rear guard tightly by turning the guard mounting nut clockwise.
9. Insert the blade to the shaft and ensure the pin enters the blade slot.
10. Tighten the blade using the blade cap turning anti-clockwise in the direction "TIGHT"
arrow on it.
11. Fix the front guard with the logo in the upright position on the rear guard. Make sure
that they are connected from the upper side.
12. Take the front guard rim and set in grooves of the rear and front gaurds, and fix it
with screwdriver.
Note: Do not operate the fan without assembling the guards properly and tightly.
13. Set one side mist tube 14 into front guard ornament 1, the other side mist tube
inserts the mist tube fixer. Then assemble finished.
4
16
17