3B medical Lumin LM3000 Guide D'utilisation page 7

Does Lumin® cause an odor?
UVC light has no odor. The vast majority of Lumin® customers experience no odor. If
there is an odor it is likely similar to the smell of burnt hair. Household dust is 90%
composed of dead skin cells. Skin, like hair, contains a sulfide molecule. UVC light
kills pathogens by destroying DNA with high energy light. That process also frees
the sulfide molecule in a skin or hair molecule. If your unit has an odor please wash
thoroughly with a damp cloth using Dawn liquid detergent and dry with a paper towel.
Run one cycle with the drawer empty and let the device sit overnight. Next day, your
unit should have no odor. If you have any questions or comments, please feel free to
email us at support@kegocorp.com.
Your Lumin® is warranted for a period of 2 years from time of purchase to
be free from manufacturer defect or workmanship. Should you encounter a
warranty issue please contact your home care dealer where you purchased the
device.
It is at the discretion of KEGO Corporation to repair, replace or exchange your
Lumin® unit should it be necessary. KEGO is not liable for misuse, mishandling
or breach of this written guarantee. Attempts to alter the Lumin® in any way
will void warranty.
This equipment has been tested and found to comply
with the limits for a Consumer ISM equipment,
pursuant to Part 18 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation."
Please note that changes or modifications of this
product is not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
WARRANTY
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This product may cause interference to radio
equipment and should not be installed near
maritime safety communications equipment, ships
at sea or other critical navigation or communications
equipment operating between 0.45-30 MHz.