Master TAKE CONTROL UR81SLR Guide De L'utilisateur page 13

All manuals and user guides at all-guides.com
•
Tube lighting and bright sunlight can affect the
procedure.
•
Use the buttons L1, L2, L3 and L4 to learn the codes
for which the Take Control remote control does not
have a proper button. If you encounter any problems
when learning the codes of buttons, erase the memory
and start again.
•
You can only learn the codes for one original remote
control per mode, e.g. the codes for your DVD remote
control under the DVD button. With some combi
devices (e.g. a TV with built-in DVD player) you first
have to learn the TV functions in TV mode and then the
DVD functions in DVD mode.
Learning the commands
1. Point your existing remote control at the Take Control
Remote (front to front). Keep a distance of 2,5 cm between
the remote controls.
2. Press the SETUP (8) button until one of the Mode LED's
stays lit. Release the SETUP (8) button.
3. Press the Mode button (TV, AUDIO, SAT, etc.) for the
device you want to learn. The LED will flash once.
4. Press the LEARN (24) button. The LED will flash once.
5. Press the button on the Take Control remote you want to
store the new command under. The LED will blink once.
6. Depending on the type of remote control you have, you
can use one of two methods:
a. Press the button on the existing remote control
you want to learn. Keep this button pressed until
the LED on the
extinguishes. If the LED does not extinguish, but
starts flashing, you need to use method B. (If you
have just tried method A and want to try method B,
first repeat step 5).
b. Press the button on the existing remote control
you want to learn. Keep this button pressed as
long as you would when using the original remote
control.
7. Repeat steps 5 and 6 for every button you want to learn.
8. When you have finished learning the buttons, press
SETUP (8)
Erasing the commands learned per mode to clear
memory space
You can erase the commands learned and saved for each
separate function (TV, VCR, etc.):
1. Keep the SETUP (8) button pressed until one of the Mode
LED's stays lit. Release the SETUP (8) button.
2. Press the Mode button of your choice (TV, VCR, etc.).
The LED will flash once.
3. Press the LEARN (24) button twice.
4. Press SETUP (8). The LED will extinguish after a few
seconds.
5. All commands learned and saved for the selected function
have now been erased.
P/N 033000=13891 13
Take Control Remote
Rev.15-05-06