Jimmy JV83 Mode D'emploi page 10

Cleaning and Replacing Parts
Note:
1. HEPA filter is available for sale from local vacuum cleaner distributors.
2. It is recommended to clean the dust cup after each use; When the dust cup is full or the HEPA filter is
clogged, it needs to be cleaned and replaced if necessary. Floorhead brushroll might be entangled with hair
after long time use, it needs to be cleaned in time to keep the vacuum working more efficiently.
Cleaning Dust Cup and Filtration System
Clean dust cup
Pull out downwards the dust cup On/ off button to
dump dust in dust cup.(Picture 18)
Press hard the dust cup release button, hold steady
the main body with right hand, rotate the dust cup
in the direction shown on the picture, remove the
dust cup from main body to further clean the dust
cup.(Picture19)
Clean filter system
Hold the mainbody, take the HEPA upwards as
shown on the picture, take out the HEPA, then
take out Grade 2 cyclone system, clean them.
(Picture20)
Fix inlet HEPA, rotate the HEPA cover in the same
direction shown on the picture, separate the
HEPA cover from inlet HEPA, which will be easily
cleaned. After cleaning and drying, assemble again.
(Picture20&21)
Cleaning Electric Brushroll
1.Use your finger to release the brushroll button,
take out the side cover of the brushroll.
2.Take out one side of the brushroll in the same
direction as shown on the picture, then brushroll
can be taken out to clean.
3.After cleaning and replacing, reassemble
it.(Picture22&23)
18-1.
Dust Cup On/off Button
19.
Dust Cup Release Button
20.
Grade 2 cyclone
21.
HEPA cover
Inlet HEPA
23-1.
①
Brushroll
release button
Brushroll
②
cover
8
18-2.
HEPA
22.
23-2.