Inserting And Replacing Batteries - OWIM H13726 Instructions D'utilisation Et Consignes De Sécurité

the transmission range. Check the signal reception
on the weather station before final assembly.
When you have found a suitable position, ensure
that the surface is completely horizontal to guarantee
accurate rainfall measurement.
The rain gauge can simply be stood in the desired
position or fixed with the screws provided.
1. Mark the drill holes using the rain gauge before
drilling the holes (ø 5 mm), ensure that no elec-
trical cables or water pipes can be damaged.
2. Push the supplied dowel into the drilled hole
until it is flush with the wall.
3. Fix the rain gauge with the screws provided.

10. Inserting and replacing batteries

Put the batteries first into the outdoor
sensor (wind gauge / rain gauge), then
into the weather station.
Wind gauge:
– The wind gauge must be recalibrated when using
it for the first time as well as every time the battery
is replaced. Please refer to section 12.1. To open
the battery compartment, loosen the 4 cross-head
screws on the battery compartment cover.
– Lift off the battery compartment cover.
– Insert the batteries (2 x 1.5 V type AA) ensuring
correct polarity. Ensure that the black strap lies
under the batteries. This strap can be used to
remove the batteries when they need to be re-
placed.
– Place the battery compartment lid on the bat-
tery compartment again. Ensure that the sealing
ring on the battery compartment is positioned
correctly in the recess. Only then is the battery
compartment waterproof.
– Tighten the 4 screws on the battery compart-
ment cover again.
Commissioning / Inserting and replacing batteries
Weather station:
– Open the battery compartment on the rear of
the weather station in the direction of the arrow.
– Insert the batteries (6 x 1.5 V type AA) ensuring
correct polarity. When one of the two battery
rows is full, a beep sounds.
– Place the battery compartment cover on the
battery compartment to close. Push the battery
compartment cover in the opposite direction to
the arrows until it engages.
Rain gauge:
– Use a slotted screwdriver to loosen the 2 adja-
cent fastening screws on the housing of the rain
gauge.
– Lift the housing carefully off the base of the device.
GB/IE 29