Karibu 52768 Instructions De Montage Et Mode D'emploi page 16

Saunaofen_EXTERN_neu_:Saunaofen Thermic Kompakt 8spr 24.06.10 12:34 Seite 16
GB
Switch off the stove and allow it to cool before you clean it.
Do not use scouring cleaning products to clean the stove.
Liquids
The sauna stove is suitable for sauna liquids.
Refer to page 14:
General instructions for using liquids and the evaporator
Troubleshooting
The stove will not heat up...
b Have you activated all the necessary switches?
b Has the fuse in the domestic installation tripped?
b Have you set the temperature controller correctly?
b Defective sauna control unit (sensor breaker, see operating manual for
the control unit).
b RCCB trips – see the section entitled "Testing the insulation resistance"
The stove causes "cracking noises"
b The case parts and heating elements expand when the stove is heating
up or operating. The heating elements may move the sauna stones and
cause noises. Cracking noises are normal and are not grounds for
complaint.
Sauna stones split and cause an odor
b Use only sauna stones recommended by the manufacturer.
b Sauna stones are too old; replace them.
The cabin does not get hot enough
b The sauna stove is too small (see Table 1)
b Humidity mode activated? The cabin temperature may be limited.
Switch off humidity mode for Finnish saunas.
b Excessive temperature loss from the sauna cabin, for example due to
poor or lack of sealing.
b Incorrect display on the sauna thermometer. Mount the thermometer
higher and at a distance of approx. 3 cm from the sauna wall.
b Have a defective heating element (heating element does not glow)
checked and measured by an electrician.
The evaporator does not work
b The tank has not been fitted correctly
b The evaporator controller has not been activated
b No water in the tank
b The controller's safety cut-out is active.
The temperature cut-out has tripped. Press the Reset button and find
b
the cause of the problem.
16