iStorage diskAshur DT2 Guide De Démarrage Rapide page 6

Adding a New User PIN in addition to the Admin PIN
In addition to the Admin PIN, the diskAshur DT
To create a new User PIN follow the steps below.
1. In Standby State (solid RED
press and hold down both the 'UNLOCK
and number '1' buttons.
2. Enter your Admin PIN (default
'11223344') and press the
'UNLOCK' button.
3. In Admin mode (solid BLUE
and hold down 'UNLOCK + 3' buttons.
4. Enter your NEW User PIN and press
'UNLOCK' button.
5. Re-enter your NEW User PIN and
press 'UNLOCK' button.
6. To exit Admin Mode press the 'LOCK'
button.
Unlocking with either the Admin or User PIN
Unlock with Admin PIN [ (UNLOCK + 1)
1. To unlock as the Administrator, in Standby state
(GREEN and BLUE LEDs will blink together), next, enter the Admin PIN and press the "UNLOCK" button, LED will
change to a solid BLUE and finally press the 'UNLOCK' button again - LED changes to
is unlocked.
Unlock with User PIN [ (
2. To unlock the diskAshur DT
your User PIN and press the 'UNLOCK' button again.
and finally changing to a solid
For more features and detailed instructions please refer to the user manual pre-loaded on your new diskAshur DT
and also available on our website.
iStorage Limited, iStorage House, 13 Alperton Lane, Perivale, Middlesex, UB6 8DH, England
Telephone: +44 (0) 20 8991 6260 - Website: www.istorage-uk.com - Email: info@istorage-uk.com
6
can be configured with an independent User PIN.
2
LED),
LED), press
+ (Admin PIN)
(RED LED) press and hold down both 'UNLOCK + 1' buttons
) + (User PIN) + (
as the User, press the 'UNLOCK' button, all LEDs will blink on and off, then enter
2
GREEN
GREEN LED indicating the drive is unlocked and ready to use as the User.
Solid RED LED will change to blinking
BLUE LEDs.
GREEN and BLUE LEDs blink rapidly together for a
few seconds then to a solid GREEN
BLUE LED indictaing the diskAshur DT
Mode'.
Solid BLUE LED will change to blinking
solid BLUE LEDs.
Blinking GREEN and solid BLUE
a single GREEN LED blink and then back to blinking
GREEN and solid BLUE LEDs.
GREEN LED rapidly blinks for a few seconds then
changes to a solid BLUE LED indicating the User PIN
has been successfully created.
Solid RED LED indicates the drive is locked and in
the standby state.
+ ( ) + ( ) ]
GREEN
) ]
and BLUE LEDs will alternately blink several times
GREEN and
and finally a solid
is in 'Admin
2
GREEN and
LEDs will switch to
indicating the drive
2
6