Schneider Airsystems KTP 310 ALU Notice D'utilisation D'origine page 4

GB
KTP 310 ALU
Table of contents - Part 1
1.1 Scope of delivery ......................
1.2 Conventional use ......................
1.3 Technical data ..........................
1.4 Symbols and their meaning ........
1.5 Components.............................
1.6 Commissioning .........................
1.1 Scope of delivery
– Cartridge gun
– Instruction manual
1.2 Conventional use
The compressed air-operated Cartridge gun
is suitable for sealing joints; for example in
glass, ceramics, wood, metal,
masonry and plumbing with
commercially available:
• plastic cartridges,
• Aluminium cartridges and
• silicone puppets
with volume of 310 ml.
Any other type of use is considered contrary
to the intended use.
1.3 Technical data
see Figure A
1.4 Symbols and their meaning
Q
Air consumption [l/min]
Max. permissible pressure [bar]
p
max
Working pressure [bar]
P
Cartridge size [ml]
V
Puppet size [ml]
V
Support
[mm]
Support puppet diameter [mm]
Recommended
(inner) at L= 10 m [mm]
10 m
I/2
cartridge diameter
hose diameter
Overall
H T
depth x height [mm]
B
2
Weight [kg]
2
m
2
1.5 Components
2
01 Plug nipple
2
02 Trigger lever
2
03 Air regulation
04 Cartridge housing
05 Union nut
06 Union nut
08 Telescope piston
09 Attachment for silicon puppets
1.6 Commissioning
Caution: Depressurise the unit!
Use with cartridges:
1. Unscrew
(Figure 2).
2. Cut off the cartridge at the threaded
stem.
3. Screw on the threaded tip.
4. Operate without attachment (item 09).
5. Guide the cartridge into the housing
(item 04) (Figure 2).
6. Screw the union nut (item 05) tightly
(Figure 2).
Use with silicon puppets:
1. Unscrew the housing (item 04) from the
union nut (item 06) (Figure 3).
2. Remove the telescope piston (item 08)
and install the attachment (item 09) on
the front piston (Figure 5).
3. Assemble in reverse order.
4. Unscrew
(Figure 2).
5. Insert the silicon puppet into the hous-
ing.
6. Cut the silicone puppet open at the front.
7. Inset the nozzle into the union nut
(item 05).
8. Screw the union nut (item 05) tightly
(Figure 6).
dimensions:
the union nut
the union nut
width x
(item 05)
(item 05)