Publicité
Les langues disponibles
Les langues disponibles
Paragraph 8 – Flow Calibration
Programming
PROG
-
-
Pump Calibration
2.00 L/H
Pump Calibration
Manual
-
Pump Calibration
Automatic
-
Paragraph 9 - Statistics
Programming
PROG
-
-
Statistic
Hours
10
Statistic
Strokes
1000
-
Statistic
Q.ty(L)
100
-
Statistic
Power
10
-
Statistic
Reset
ESC
Statistic
Hours
10
-
Paragraph 10 - Password
Programming
PROG
-
-
Password
****
Password
0000
-
0000138025
-
Pump Calibration
+
2.00 L/H
Automatic Cal.
2000 ml/H
Automatic Cal.
80 sec
-
Automatic Cal.
+
100 gr
-
Statistic Reset
+
NO
-
+
The memorised cc value per strike appears in the main
menu. It can be calibrated in two different ways:
MANUAL – manually enter the cc value per strike using the
keys and confirm by pressing the
AUTOMATIC – the pump makes a dosing phase, which are
started by pressing the
enter the quantity sucked up by the pump using the
keys and confirm by pressing the
The entered figure will be used in flow calculations.
The main menu displays the pump operation times. By
pressing the
- Q.ty (L) = quantity dosed by the pump in litres
- Power = number of pump starts
- Reset = use the
otherwise (NO), then confirm by pressing the
Pressing the
By entering the password, you can enter the programming
menu and see all the set values. The password will be
requested whenever you seek to modify them.
The flashing line indicates the number than can be modified.
Use the
key to select the number (from 1 to 9), and the
key to select the number to be modified. Confirm by
pressing the
password is eliminated.
rev. 1.0 EN
Operation
key. At the end of this process,
key.
Operation
key you can access other statistics:
to reset the counters (YES) or
key will take you back to the main menu.
Operation
key. By setting "0000" (default), the
key
key.
8
Publicité
