Troubleshooting Guide - Daga Flexyheat CIN Mode D'emploi

ENGLISH
ture to a lower level after this time.
The control should be set to its minimum temperature (level 1)
when using the product for extended periods of time. Try to avoid
excessive exposure to heat from high temperatures The highest
control temperature level (level 4) should be used only for the time
necessary to obtain a comfortable temperature, and the temperature
should be gradually lowered to a lower position after this threshold
has been reached.
TROUBLESHOOTING GUIDE: Possible operatio-
nal problems
PROBLEM RECOMMENDATION
Make sure that the regulator is properly
connected to the product.
If the electric blanket is not heating up,
cover it with a bed cover, or duvet , placing
After turning on the the regulator in the maximum position and
electric blanket, it
wait for 30 minutes. If it continues to not
does not warm up or heat up after this time, contact an authori-
only heats up a little. zed service technician.
Checks carried out with the electric
blanket partially uncovered or in the open
air are not reliable, as these may result in
erroneous perceptions of the heat.
The product has an auto-stop system that
After a certain activates after 90 minutes of continuous
operation time, operation. After this time, the light on the
the product regulator starts to flash.
temperature If you want to continue to use it, change
seems to reduce. the temperature level to level 0, wait a
few seconds, and then select the desired
temperature.
Ensure that the regulator is properly
The regulator control
connected to the product and that there is
does not turn on
voltage in the socket
when the switch is
of the mains used ,and that the product is
activated.
properly plugged in to the same.
PRODUCT DISPOSAL AND CONSERVATION
PRODUCT CONSERVATION
Unplug the product when you do not intend
to use it for an extended period of time to
prolong its shelf-life. Prior to storing the pro-
12
ENGLISH
duct, allow it to cool before folding, keep it
in its original packaging in a dry location with
the fewest possible folds, without placing any
objects on top.
PRODUCT CLEANING
The product has a removable connection.
Always unplug the plug from the socket and remove the product from
the control connection prior to cleaning the product (See Fig. 3.)
The product can be washed by hand or in a washing machine, using
liquid detergent and selecting the delicate wash program set to a
short cycle.
Ensure that your washing machine can withstand the weight of the
electric blanket when it is wet.
To prevent damage to the product, DO NOT wash the product with
the control knob attached.
Hang the product horizontally and do not wring or fold during
drying.
Do not use in the dryer.
Do not use a hair dryer or other similar electronic devices.
If it is damp, leave it to dry prior to plugging it into the mains again.
Do not wash this product in a dry cleaners or launderette in order to
ensure its proper operation and prevent any damage.
Electric blankets should never be ironed.
To extend the shelf life and maintain the hygiene of the product, do
not lie directly on top of it, always covering it with the under sheet,
as shown in the Instructions for Use section of this manual.
PRODUCT DISPOSAL
Do not dispose of the product at the end of its shelf-life. Contact
the organic collection centre closest to your home in accordance
with the waste electrical and electronic equipment (WEEE) Directi-
ve 2012/19/EU to contribute to the protection of the environment.
Request detailed information regarding their current methods of
disposing of packaging and scrappage of used devices from your
distributor.
We hope that you will be satisfied with this product.
We hope that you will be satisfied with this
product.
13