AcousticSheep SleepPhones Instructions D'utilisation page 3

Operating Instructions:
1. Click the button on the wireless Bluetooth
volume will cycle up and down in 10% increments.
2. Double-click the button to pause the music. Double click to resume playing music.
3. To turn the device off, press and hold the button for 2 seconds. A voice will
announce, "Power off."
Troubleshooting:
1. Check the volume on your Bluetooth
2. Check the volume on the wireless Bluetooth
3. Make sure that the wireless Bluetooth
4. Refer to your phone, computer, or other Bluetooth
5. While charging, if you do not see a green or red light on the wireless Bluetooth
receiver, use your hand to block out light and look closely. It may be dim through
the fabric.
6. To improve reception, the button on the gray square Bluetooth receiver should
point away from the head. Also make sure that the antennae of your music player is
not covered.
If your Bluetooth device is separated from your SleepPhones
®
more than 5 minutes, the headphones will automatically power off. Not all applications or
software support Bluetooth
C A R E A N D W A S H I N G
Remove speakers before washing fleece headband. Machine wash warm. Tumble dry
medium. Do not iron, bleach, or dry clean. Avoid fabric softeners because they reduce
wicking.
Insert the speakers when the band is dry. The right speaker is red and the left speaker is
green. The white side should be against your ears. Insert speakers about four inches, then
insert the gray wireless Bluetooth
Visit www.sleepphones.com/video for video instructions.
w w w . S l e e p P h o n e s . c o m w w w . S l e e p P h o n e s . c o m
®
device.
®
receiver is charged.
®
.
®
receiver before closing the Velcro
®
receiver to change the volume. The
receiver located inside the headband.
®
device manual.
®
Wireless headphones for
®
. Adjust for fit.
®
ENGLISH
®