Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Mounting the Hood
CAUTION
Hood is intended to be mounted to a finished
Ceiling Preparation
1. Determine hood mounting location and
temporarily tape paper template (included with
the hood) to the ceiling.
2. Cut-out internal shaded area of template
to allow the ducting and electrical to pass
through (approx. 7"W x 7-1/2"D).
3. Add wood blocking (min. 2" x 4") onto ceiling
joists to reinforce ceiling above the drywall.
(FIG. C1).
4. Secure (2) #6 x 1-1/2" wood screws into points
A and B of the paper template (FIG. B). Do not
completely tighten screws, leave approximately
1/4" exposed.
Hood Preparation
5. Remove screws securing top and bottom
support frames together.
6. Adjust support frame to accommodate the
desired hood height and re-assemble the frame
using the previously removed screws (2 screws
for each support frame arm). (FIG. C2).
14
ceiling.
Front of Hood
Cut-Out Shaded Area
A
FIG. B
Ceiling Joists
Wood Blocking
Top Support Frame
Bottom Support Frame
Hood Body/Canopy
FIG. C
BML-C Use, Care, and Installation Guide
B R I S A S
I S L A N D
C L
B
1
3
2
B M L
4
Publicité
