Installation And Fixing - Bauknecht Domino 300 Mode D'emploi

41902042GB.fm Page 13 Wednesday, June 22, 2011 10:28 AM

Installation and fixing

Warning! The installer is responsible for any
damage or injury resulting from incorrect
installation.
To guarantee correct operation, the appliance
must be installed on a perfectly flat surface.
For cut-out dimensions, see the figure below.
Domino
300 288
484
min. 50
+2
0
490
To guarantee correct operation, the appliance must be
installed on a perfectly flat surface.
The worktop must be 20-50 mm thick.
If necessary, cut the kitchen unit and worktop to fit before
installing the hob. Clean the cutout of any remaining dust
that could compromise appliance operation.
For the distance between the underside of the induction
hob and the kitchen unit (or separating panel), observe the
dimensions given in the figure at the side. If a column unit
Assembly
1. Position the clips (A) in the spaces provided on the
hob trim ( fig. 3 ) if not already positioned.
2. Measure the centre point of the vertical sides of the
cut-out ( fig. 1 )
3. Fit the brackets (C) in the centre of the vertical sides,
aligning the upper edge of the brackets so that they are
510
+1
0
51
267
R min. 6.5
max. 8
+2
380
0
275
Domino
380
484
min. 50
+2
0
490
fig. 1
13
The worktop must be 20-50mm thick.
If necessary, cut the kitchen unit and worktop to fit before
installing the hob. Clean the cutout of any chips that could
compromise appliance operation.
77x35
770
325
min. 50
+2
0
330
510
+1
0
51
342
R min. 6.5
max. 8
+2
0
350
is installed adjacent to the hob, leave a distance of at least
100 mm from the edge of the hob.
min. 20
min. 5
flush with the worktop surface (
4. Fix the brackets with the 4 screws supplied (B) using
the holes provided.
5. Insert the hob in the cutout, making sure the clips (A)
are secured in the spaces provided (
C
B
350
+1
0
52
743
R min. 6.5
max. 8
+2
0
750
Dimensions
in mm
fig. 2 ).
fig. 4 ).
fig. 2