Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User manual
1.
BEFORE YOU START
1.1 What is included
High Lumen LED strips 24V
1.2 Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all
parts are present, and have been received in good condition. Notify the shipper immediately and retain
packing material for inspection if any parts appear damaged from shipping or the carton itself shows
signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be
returned to the factory, it is important that the fixture be returned in the original factory box and packing.
2.
USAGE
• Mounting and connecting LED strips can only be done by a professional.
• All LED strips give off heat, and they have to get rid of this heat in order not to be damaged. All LED
strips must therefore be mounted on a metal (aluminum, steel) surface so that cooling is assured. Even
a small interruption of the profile can damage the LED strip.
• Our LED strips can all be controlled 24V (5V for the data LED strips). So you must provide a power
supply with an output of 24V, and with enough wattage to power the LED strip. The wattage per meter
is stated on each LED strip. For a LED strip of 5m, the total consumption is therefore 14w / m * 5m =
70 Watt. So make sure that the power supply can deliver at least 70W. It is recommended to take the
diet at least 20% heavier than the consumption. In this case, a 100w power supply would be perfect.
• LED strips can be cut to length and soldered together again. You can only do this at the designated
places. Cut neatly between the copper connection plates with a sturdy pair of scissors or a good utility
knife in the indicated place.
• Connecting the LED strips to the power supply and reconnecting the LED strips is done with a cable of
at least 0.5 mm², and solder on the provided points. This must be done by a technician. It is
recommended to provide the connection and the connection with a crimping gaine.
• The strips are designed to be fed per 5 meters. You cannot connect endlessly; you must feed again
every 5 meters.
High Lumen LED
8
Publicité
Table des Matières
