Publicité
CONCORDIA AUTOMATIC
DESCRIPTION
18
Crown
Position 1
Position 0 (unscrewed)
Position 0 (screwed)
Date
Rotating bezel
Set the time
1 — Unscrew the crown.
2 — Pull the crown out to position 2.
3 — Turn the crown to set the time
4 — When set, press the crown to put it back to position 0 (unscrewed).
5 — Screw it back.
Set the date (Do not change the date when the hour hand is between 9pm and 3am)
1 — Unscrew the crown.
2 — Pull the crown to position 1.
3 — Turn the crown clockwise to set the date.
4 — When set, press the crown to put it back to position 0 (unscrewed).
5 — Screw it back.
Manual winding (approximately 38 hours of power reserve)
1 — Unscrew the crown.
Position 2
2 — Turn the crown (position 0 unscrewed) 30 to 40 times clockwise to fully wind the watch.
3 — Screw it back.
Diving bezel
The unidirectional rotating bezel allows you to point the arrow precisely to the desired hour or minute (120 notches). When
measuring elapsed time at the maximum depth of your dive, if you make a mistake and the bezel rotates, this can only set
back the time you initially indicated, making it impossible to miscalculate your stop times and risk decompression sickness.
INSTRUCTIONS
19
Publicité
