User Servicing Instructions; Maintenance Instructions - Lorell 49251 Manuel D'utilisation

USER SERVICING INSTRUCTIONS

1. Grasp plug and remove from the receptacle or other outlet device. Do not
unplug by pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug
towards blades.
3. Remove fuse carefully. Insert the tip of your tool into fuse slot (close with the
terminal), then prize the fuse gradually and slowly, but not overexert. If you
feel tight, you can try it at several times and prize the fuse little by little. When
one side of the fuse has been prized, then you can get the fuse out entirely.
4. Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed.
Discard product if the attachment plug is damaged.
NOTICE:
1. When you replace the fuse, please don't operate suddenly or overexert, or else the product will be damage or
cause accident.
2. When you feel it hard to be operated, please make sure you have got the right way.

MAINTENANCE INSTRUCTIONS

The fan requires little maintenance. Do not try to fix it by yourself. Refer it to qualified service personnel if service
is needed.
1. Disconnect from power source prior to cleaning or servicing.
2. Please wipe the exterior parts with a soft cloth soaking a mild detergent. Do not use any abrasive detergent or
solvents to avoid scratching the surface.
3. Do not allow water or any other liquid into the motor housing or interior parts.
4. Clean with a small brush, then wipe with a slightly damp sponge and dry thoroughly with a soft cloth. Exterior:
Wipe surface with a clean, damp cloth. Do not use abrasive cleaners, as they may scratch the surface.
CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and a damp cloth or sponge. Thoroughly to remove soap film
with clean water.
3. Be sure not to make water or other liquid enter inside of motor.
LLR49251_UserManual.indd 7
7
10/26/18 3:17 PM