Safety Regulations; Layout And Items Supplied; Technical Data - EINHELL TE-CL 18 Li - Solo Mode D'emploi D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. On/Off switch
2. Setting wheel
2.2 Items supplied
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Battery-powered lamp
•
Original operating instructions
GB

3. Technical data

Power supply: ......................................... 18 V DC
Number of LEDs: .............................................. 3
Lumens: ....................................................270 lm
Weight: .......................................................0.3 kg
4. Operation
4.1 Mounting on the battery (Fig. 2)
•
Push the lamp onto the battery until it snaps
into place.
•
To separate the battery again, press the
battery's pushlock button (a) and pull the
lamp off the battery.
4.2 On/Off switch (Fig. 1/Item 1)
To switch on:
Press the On/Off switch (1).
To switch off :
Press the On/Off switch (1) again.
4.3 Setting the lighting position (Fig. 3)
You can set any lighting position by moving the
lamp head (see Fig. 3).
4.4 Setting the angle of diff usion
(Fig. 4/Item 2)
You can set the angle of diff usion by turning the
setting wheel (2) to one of 2 positions.
Position A:
Small angle of diff usion
➜ Small area, high level of luminance
Position B:
Large angle of diff usion
➜ Large area, low level of luminance
- 11 -