Leatt 3DF AIRFIT EVO BACK PROTECTOR Mode D'emploi page 4

Leatt ® Corporation's personal protective equipment is not designed or intended to protect a
wearer against serious bodily injuries caused by hard collisions or crashes. Protective equipment
such as stone shields offer protection only against lofted stones or debris. Protective equipment
such as back or lumbar protectors do not protect against spinal injury. No protective equipment
can protect the wearer from all foreseeable impacts.
Testing and Approval
The Leatt® Back Protector 3DF Airfit EVO has been tested against the manufacturer's specifications and EU
Type – Examination certification has been issued by RICOTEST Via Tione, 9 - 37010 Pastrengo (VR), European
Notified Body No. 0498. It is CE marked to denote compliance with the Personal Protective Equipment
Regulation (EU) 2016/425.
The following European Standards have been used in the evaluation of this product:
- EN1621-2 Level 2 – "Motorcyclists' protective clothing against mechanical impact - Part 2: Motorcyclists'
back protectors"
- EN 13688:2013 – "Protective clothing - General requirements"
Note 1: The inclusion of CE approved armor within this garment does not imply that the whole garment is CE approved.
Note: To view the Declaration of Conformity to PPE Regulation (EU) 2016/425 please navigate to leatt.com
and select the DOCUMENTS tab on your product's page.
Protection provided
Protector conforms to the EU Personal Protective Equipment Regulation 2016/425.
Back protection conforms to the Level 2 requirements of EN 1621-2:2014
Leatt ® protector back plates have been tested to EN1621-2:2014 and recorded a mean transmitted force of
below 9kN from a 50 Joule impact (Level 2).
Use
Products meeting the requirements of the technical specifications listed above are intended to reduce the
severity or incidence of soft tissue injuries such as bruising, contusions, cuts and abrasions during off-road
motorcycling and biking activities, such as Moto-X, Enduro, Downhill MTB, BMX and Adventure Sports.
- Products meeting the requirements of the technical specifications may reduce the severity and/or
incidence of some more serious injuries such as minor fractures.
- Products meeting the requirements of the technical specifications cannot significantly mitigate against
major injuries, such as serious fractures resulting from extreme impact forces or torsion/flexion/bending/
crushing injuries and neurological spinal injuries. Currently available materials and technology do not allow
this level of protection to be attained in products which would be acceptable to wear and which would
allow physical activities to be conducted and completed satisfactorily.
4
WARNING
Copyright © 2023, Leatt ® Corporation