Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RADIANT
design D. D'URBINO P.LOMAZZI coll. CASATI
TABLE OPERATING INSTRUCTIONS ON AUTOMATIC MODE
•
To activate the table electronic functions without charger it is necessary, the first time only, to insert the battery in the engine
block.
•
The table with the charger works also without the batteries.
•
Battery insert:
•
Remove the back panel of the remote control box by taking away the 2 screws. FIG.XIII
•
Connect the cables to the battery following the colors of the cables to match the color marked on the battery (red to red, black
to black) and then insert the battery in the slot as shown in FIG.XIV
•
Put again the back panel on the remote control box by tightening the 2 screws.
•
Now make sure that the table is placed in the (automatic position) position automatically as in FIG.XV so that it is inserted
the knob into the hole 2 and screw.
•
In this position the table will be able to be used only in the automatic mode.
TO AVOID THE COMPLETE BLACK OUT OF THE BATTERY WITHOUT THE CHARGER, IF THE TABLE
!
IS NOT WORKING FOR 3 MIN. AND THE BUTTON IS OCCASIONALLY LEFT ON "I/ON", THE SYSTEM
AUTOMATICALLY CUTS OUT. TO START IT UP AGAIN, PLACE THE BUTTON ON "O/OFF" FOR 3
SEC. AND THEN ON "I/ON"
WARNING!
!
ONLY MOTOR VERSION. BEFORE USING THE TABLE IT IS NECESSARY TO CHARGE THE BATTERY
AT LEAST FOR 24 HOURS, TO AVOID ANY DAMAGE (FOLLOWING RECHARGE
HOURS)
!
CLOSE
OPEN
FIG.XIV
2
CLOSE
OPEN
OFF
!
FIG.XV
ON
FIG.XIII
!
2
GB/ 23
AT LEAST 12
A
Publicité
Table des Matières
