Nice RMEKIT 3017 SH Instructions Et Avertissements Pour L'installation Et L'utilisation page 13

PRODUCT FAMILIARISATION AND INSTALLATION PREPARATION
––– PHASE 2 –––
2.1 - PRODUCT DESCRIPTION AND APPLICATION
This kit contains a tubular motor and other accessories. The kit is exclu-
sively intended for automating a shutter already equipped with a sheet
metal winding roller, with octagonal cross-section (fig. 2). One end of the
roller must already be fitted with a cap including a system for attachment
to a bracket secured to the wall (fig. 3). Moreover, the internal length of
the roller, used to contain the motor, must take into account the motor's
length (fig. 4). Any other use is prohibited! The manufacturer is not
liable for damage resulting from improper use of the product, oth-
er than that which is provided for in this manual.
The tubular motor, through the use of adapters supplied for the purpose,
is installed by mounting it on the interior of the roller tube and the whole is
then affixed to the inside of the case (located above the roller shutter) us-
ing the supplied components.
The motor has command logic (integrated) with electronic limit switch
which halts movement of the roller shutter when the motor reaches the
following positions: the position when it completes the upward movement
(maximum opening: in the manual this is called "limit switch 0") and the
position when it completes the downward movement (maximum closure:
in the manual this is called "limit switch 1").
After limit switch programming, sending a command via the control trans-
mitter will activate the roller shutter movement, which will stop automati-
cally when the stored "limit switch point" has been reached.
2
5
code RME 3017 SH
h
code 535.10099
3
a
code STX100
f
The motor is intended for domestic purposes, not for intensive use. As a
result, in the event of overheating – for instance, due to continued actua-
tion – thermal safety protection automatically intervenes by cutting off the
electrical power supply and subsequently reconnecting it once the tem-
perature returns to normal values. In all cases, a continuous working time
of 4 minutes maximum is ensured.
2.2 - COMPONENTS CONTAINED IN THE KIT
Important! – Before proceeding with the installation, it is necessary to
check the integrity of the components present in the RMEKIT 3017 SH
kit and familiarise yourself with their names. This kit includes the following
components (fig. 5):
[ a ] - Tubular motor (Ø 45 mm): code RME 3017 SH.
[ b ] - Transmitter to command the one shutter or a group of roller shut-
ters: code STX100.
[ c ] - Motor adaptor set for 60 mm octagonal tube: code 515.06000.
[ d ] - Motor adaptor set: code 515.26254.
[ e ] - Motor adaptor set: code 515.26264.
[ f ] - Motor adaptor set: code 575.01011.
[ g ] - Support to fix the motor head: code 535.10099.
4
b
code 575.01011
586 mm (RME 3017 SH)
c
code 515.06000
d
code 515.26254
e
code 515.26264
English – 2