Strip Circuits - Jenn-Air JGCP430 Instructions D'installation

To Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove burner cap.
3. Remove the burner base.
A
B
C
A
B
4. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into gas opening and press down onto the
gas orifice spud and remove by turning the gas orifice spud
counterclockwise and lifting out. Set gas orifice spud aside.
5. Replace with correct Natural gas orifice spud. See the
"Natural Gas Orifice Spud/Hood Chart."
Burner orifice spud
A. Size stamp or color
Use the following chart to find the exact orifice spud
placement.
Remove choke from medium burner base.
Griddle 120V Control Wiring Diagram to Cooktop Stand-Alone
Large Dual Burner
A. Burner cap
B. Burner base
Medium Burner
A
A. Burner cap
B
B. Burner base
C. Choke (for use with medium
burner, LP gas only)
Small Burner
A. Burner cap
B. Burner base
A

STRIP CIRCUITS

R P2-1
Rotary Control
W P2-6
Natural Gas Orifice Spud/Hood Chart
Burner
Color
Rating
5,000 BTUs NG 5k
Small
burner bag
15,000 BTUs No color
20,000 BTUs Blue/Yellow
Black
6. Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
NOTE: There may be extra orifices in your kit.
7. Replace the burner base.
8. Replace burner cap.
9. Repeat steps 2 through 8 for the remaining burners.
Complete Installation
1. Refer to the "Make Gas Connection" section for properly
connecting the cooktop to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the LO setting for each
cooktop burner.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
/ " (0.64 cm) to / " (1.3 cm) long. The outer cone is not
1 1
4 2
as distinct as the inner cone. LP gas flames have a slightly
yellow tip.
3. Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
1320W/120V
OR/W
P1-1
Lamp 120V
BU
W
P1-3
RTD
V W W
P1-4
P1-6 OR/W
Size Burner Style
0.97 mm Small burners
1.75 mm Medium burners
1.98 mm Large burner - main
0.52 mm Large burner - simmer
OR/W
W
W
V V
15