Assembly; Disposal - DS Produkte Z 06442_V4 Mode D'emploi

Assembly

1. Unpack the product and the accessories and lay all of the parts carefully on an even surface
on the fl oor. Ensure that all product contents are present (see the "Product Contents and
Product Overview" chapter) and check for any damages from transport. Should you identify
any transport damages, please promptly consult the customer service.
2. Stick the alu tubes 30 mm together by using the connectors. Connect the alu tube 27 mm
with the locking ring.
3. Place the bush and the spiral spring into the cover part and stick a non-slip pad to the cover
part.
4. Put the cover part with the bush and the spiral spring on the upper end of the alu bar.
5. Insert 12 shoe holders into the slots of each of the 8 plates.
6. Slip the prepared plates over the assembled alu bar and fi x each plate with a damping ring.
Thanks to its special construction the damping ring – which consists of two parts that
fi t exactly into each other – can be stuck from both sides to the alu bar. To lock the
ring, hold the upper part and turn the lower part to the ring until it locks in position.
Do not tighten it too fi rmly!
7. Now stick the second non-slip pad to the foot part and put the foot part in the lower end
of the alu bar.
8. Fix the shoe rack between ground and ceiling in a vertical position. While pressing the bar
against the ceiling, the spiral spring compresses and is under pressure now.
9. Draw-out the alu tube 27 mm until it hits the ground, turn it to the right until it locks in
position.
10. After mounting the shoe rack, it must not move, neither the upper part nor the lower part.
In case of any movement of the rack, please unscrew the alu tube 27 mm and fi rmly press
the bar to the ceiling once again.

Disposal

The packaging material is recyclable. Dispose of the packaging in an environmentally-
friendly manner and make it available for the recyclable material collection-service.
Dispose of the product in an environmentally-friendly manner. For more information,
please contact the administration in your locality or a recycling centre.
Customer Service / importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany
Tel.: +49 38851 314650 *)
*) Calls subject to a charge.
All rights reserved.
06442_DE-GB-FR-NL_V4.indb 9
9
03.01.13 16:47