Fox Heat Transfer Mode D'emploi page 8

2. Completely close the gas feed by turning the flame control knob to the right
(clockwise) to OFF position.
3. Remove the protective plastic cap from the gas cartridge and carefully screw
on the stove for 3 turns — care should be taken for a little gas will be lost to the
atmosphere at this point. Do not overtighten for this may damage the stove's dual
leak-proof gasket that prevents leakage.
4. Turn the flame control knob to the left (counter clockwise) twice.
Click the piezo ignition and the gas should ignite immediately.
5. A normal flame should be stable and burn upward with a blue or saffron yellow
colour depending on flame control.
DISASSEMBLY PROCEDURE
1. Turn the flame control knob fully to the right (clockwise) to the OFF position and
check the flame is completely extinguished.
2. Allow the stove to completely cool down. Hold the stove firmly, and then turn the
gas cartridge clockwise to remove. Fold in the pot supports and put the whole
burner head into its protective storage bag.