Télécharger Imprimer la page

Fox RX+ Light Mode D'emploi page 6

Publicité

ENGLISH
6
RX+ Micron
Bite detection from an RX+ Micron takes priority over other signals and
will cause the RX+L to respond in the following ways:
(To prevent disturbing the user unnecessarily, the unit does not respond unless
at least three beeps are received in a short space of time.)
If the RX+L is in STANDBY, the main light will illuminate in the last used
colour and brightness and will stay ON for 10 seconds after the last
signal from an RX+ Micron, at which point the light will fade out.
If the RX+L is ON, the main light will flash 4 times and return to the ON
state. Continued signals from an RX+ Micron will not cause the light to
flash further, unless a 10 second period of inactivity occurs.
RX+S
Motion detection from an RX+S will cause the RX+L to respond in the
following ways:
If the RX+L is in STANDBY, the main light will illuminate in the last used
colour and brightness and stay ON for 10 seconds if RX+S is in alarm
mode, or 20 seconds, if RX+S is in floodlight mode, after the last signal
from an RX+S, at which point the light will fade out.
If the RX+L is ON the main light will flash 4 times and return to the ON
state, if the RX+S is in alarm mode. Continued signals from an RX+S will
not cause the light to flash further unless a 10 second period of inactivi-
ty occurs. No flashing occurs, if the RX+S is in floodlight mode.
Radio Compatibility (Ultra-Long Range™)
WORKS EXCLUSIVELY WITH THE RX+ FAMILY OF PRODUCTS AND IS NOT COMPATI-
BLE WITH EXISTING NON RX+ FOX BITE ALARMS.
Battery Indicator LEDs
The RX+L has 4 battery indicator LEDs
4 LEDS indicates > 75% of charge
3 LEDs indicates between 50% and 75% of charge
2 LEDs indicates between 25% and 50% of charge
1 Red LED indicates < 25% of charge
1 rapidly flashing Red LED indicates immediate charge is needed
Continuing to use the RX+L once the red battery warning LED is flashing
will result in the unit eventually shutting down to protect the battery. If
this occurs, all controls are disabled and the unit must be placed on
charge before it can operate again.
Charging the RX+L
The RX+L is supplied with a USB-C to USB-C charging cable, other
compatible cables can be used but they can have an effect on
charging speed. There is also a USB-C to USB-A adaptor supplied with

Publicité

loading