NAD 517 Manuel D'installation page 8

GB
Intro check disc play: When the PREVIEW button is
pressed during the STOP mode, upon pressing the
PLAY button, the first track on the disc number
shown in the DISC NUMBER display will be played
for about 10 seconds, then the second track on the
disc will be played for about 10 seconds. Disc play
will continue in this way until all the tracks on all the
discs have been scanned. If you press the PRE-
VIEW button during normal play, intro check disc play
begins with the next track.
If you perform the same action while the track is
played for less than 10 seconds, the intro check disc
play starts from that track.
When tracks have been programmed, they will be
scanned in order for about 10 seconds each. If the
PLAY button is pressed during intro check disc play,
the intro check mode will end and normal disc play
will continue from that point.
Selecting a Disc for PREVIEW Checking
1. Press the PREVIEW button.
2. Select a disc number using the DISC NO. button.
3. Press the PLAY button.
NOTE:
- In order to designate a track number on the disc,
press the DISC NO. button first and the press the
TRACK NO. button.
- Upon finishing the entire PREVIEW disc play, the
display changes to STOP.
PREVIEW Checking During Programmed
Disc Play
1. Press the PROGRAM button.
2. Press the PREVIEW button.
3. Press the PLAY button.
NOTES:
- Upon finishing the entire programmed intro check
disc play, the mode changes to stop for the pro-
grammed play.
- Pressing a SHUFFLE button activates intro check
disc play at random within the programmed tracks.
PREVIEW Time Setting
The time allocated for the PREVIEW can be
changed as follows:
1. Input the desired time by pressing a TRACK NO.
button (one to 99 seconds).
2. Press the PREVIEW button.
3. Press the DISC NO. button. (in order to desig-
nate a track number on the disc, press the DISC NO.
button first and then press the TRACK NO. button)
4. Press the PLAY button.
Repeat Play: Shuffle Programmed Tracks
1. Enter the program.
2. Press the SHUFFLE button.
3. Press the REPEAT Button.
4. Press the PLAY button.
5. Programmed tracks are played at random
NAD
8
repeatedly until the STOP button is pressed.
- Shuffled programmed tracks are played in a differ-
ent order during the second run and all runs there-
after.
- During repeat shuffle programmed play if the
PLAY button is pressed the shuffle programmed play
is cancelled and the programmed tracks are played
repeatedly in a programmed order.
Repeat Play: PREVIEW Disc Play
1. Press the PREVIEW button and PLAY button.
2. Press the REPEAT button.
3. Intro play is repeated for the tracks on all discs.
- If the REPEAT button is pressed again PREVIEW
play is repeated for the track currently playing, and
REPEAT ONE indicator lights.
Repeat Play; PREVIEW Play of Shuffle
Programmed Tracks
1. Enter the program.
2. Press the PREVIEW button.
3. Press the SHUFFLE button.
4. Press the PLAY button.
5. Press the REPEAT button.
6. The shuffle programmed intro scan disc play is
repeated until the STOP button is pressed.
If the REPEAT button is pressed again, repeat play
is cancelled and shuffle programmed intro scan disc
play starts.
- The REPEAT indicator goes OFF.
EDIT PLAY MODES
The tracks are selected and played so that when
recording only complete tracks will be recorded to
each side of the tape.
1. Press the STOP button.
2. Press the remote control's EDIT button once.
- The EDIT indicator lights.
- The DISC NUMBER and TRACK NUMBER dis-
plays will show "C90" (the length of the tape in min-
utes, that will be used for recording) for approximately
10 seconds.
If a C-60 or C-46 cassette will be used for record-
ing, press the EDIT button one or two more times to
select the "C60" or"C46" tape length.
NOTE:
- Other tape lengths can be selected. See
"Changing The Tape Length".
- To end edit play, press the Edit button a fourth
time or press the STOP button. The EDIT indicator
turns off.
3. Press the DISC NUMBER button which corre-
sponds to the tray number of the disc to be played.
4. Press the ">>I" or "I<<" button or the remote con-
trol's TRACK NUMBER button(s) to start edit play
from a specific track.If you wish to play programmed
selections, enter a program.