Makita DFJ210 Manuel D'instruction page 8

2. Turn the ring counterclockwise while lifting the
hook on it. Remove the ring when the mark on the ring
aligns with the slot on the fan unit.
3
► 1. Fan unit 2. Ring 3. Hook 4. Slot 5. Mark
3. Pass the head of the fan unit into the hole on the
jacket. Set the ring onto the fan unit and turn it clock-
wise until the mark on the ring aligns with the mark
further from the slot.
2
► 1. Mark 2. Ring 3. Fan unit
4
5
1
2
1
3
4. Pass the strip through the loop on the fan unit and
fasten the snap button.
1
► 1. Strip
5. Attach the other fan unit to the jacket in the same
way.
6.
Connect the power cable to the fan units. Support
the cable using the cable holder.
For model DFJ210 / DFJ211 / DFJ310 / DFJ311 /
DFJ410 / DFJ411
1
► 1. Power cable 2. Cable holder
For model DFJ212 / DFJ213 / DFJ214 / DFV210
1
► 1. Power cable 2. Hole 3. Cable holder
7.
(For DFJ212 / DFJ213 / DFJ214 / DFV210 only)
Close the zip fastener after installing or removing the
fan unit.
8 ENGLISH
2
3
2