Maintenance - Husqvarna WT 15i Manuel D'utilisation

4. Pull the power plug to disconnect the battery charger
from the power outlet. Do not pull the power cord.
To connect the battery to the battery charger
Note: Charge the battery before you use it for the first
time. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
4. When all LEDs on the battery come on, the battery is
fully charged.
A
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Technical data on page 8 and the
Note: Refer to
manuals for the battery and the battery charger for more
information.
To use embedded connectivity
Note: The instruction that follows is applicable only for
products supplied with embedded connectivity.
Note: Radio transmission by the function will be enabled
when you connect to Husqvarna Fleet Services for the
To clean the battery
CAUTION: Do not clean the battery with
water.
6
B C D

Maintenance

first time. To make this connection, the pump must be
on until the connection is complete. The function is on
after that.
1. Download the Husqvarna Fleet Services iOS or
Android app.
2. Go to https://getfleet.husqvarnacp.com for more
information.
To start the product
1. Put a battery in the battery department. For
approved batteries, refer to
8 .
2. Push the start stop button to start the product.
To stop the product
• Push the start stop button to stop the product.
Note: The pump stops automatically if the container runs
out of water
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery with a soft and dry
cloth.
Technical data on page
1572 - 001 - 21.12.2020